Cool Automation 9000H Instalační příručka stáhnout pdf (Strana 17)

Sensor Cable Guidelines

Entek 9000 Series Sensor Installation Guide 9

Sensor Cable Guidelines

This section describes some common cable guidelines to get the signal from the sensor to

the monitoring device.

Sensor Connections and Power

Most of the 9000 series sensors are two-wire, IEPE accelerometers. There are also 9000

series sensors that have a built-in integrator to produce a velocity signal, as well as

combination accelerometer/temperature sensors. The pin connections on the sensors are

listed in the following table.

Combination accelerometer/temperature sensors have three pins.

Connector Pin Function

Shell Ground, connected to cable shield

A IEPE sensor power and signal

B IEPE sensor signal return (signal common)

Connector Pin Function

Shell Ground, connected to cable shield

A IEPE sensor power and signal

B IEPE sensor signal return (signal common) and temperature common

C Temperature sensor signal and power

ide View

End View

ide View

End View

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Žádné komentáře

Cool Automation 9000H Instalační příručka Strana 17